Performance Testing

The performance testing of injector includes electrical characteristics, accuracy, the tolerance of high temperature, low temperature, pressure as well as leakage, durability and others working conditions testing. These conditions of each injector will be tested before our solenoid valve are sent to customers.

Above are the tests needed to be done after the solenoid valve are finished producing. However, regular checking also very important to keep the injector perform well.

In order to make sure the injector works normally, there are some parts of injector needed to be checked regularly and before installing to injector solenoid valve.

① Check whether there is deformation, cracking, thread damage, quenching, leakage and rust in the guide sleeve, spring, gasket and tight cap of the injector. The tight cap of the injector must be replaced after being disassembled for more than 5 times, as shown in the following.

② Replace the tight cap of the injector and the copper gasket of the injector

③ Check whether the gap between the injector needle and the injector shell is within the standard range and whether it reaches the standard for use

④All parts should be examined for wear under a microscope at least 20 times larger

⑤ injector tight cap deformation, cracking, thread damage, quenching, leakage, will lead to black smoke vehicle cap, injector solenoid valve damage.

⑥injector solenoid valve opening pressure greater than or less than the specified range may cause injector solenoid valve damage.
⑦ Failure to replace wearing parts in time during maintenance may lead to injector solenoid valve damage.

These are some precautions you need to know to maintain an injector. If there are more questions about solenoid valve and other problems, you are welcomed to contact us, injectorsolenoid.com will do the best to help you solve your problems.